Integrated BCT solutions in Siemens NX, Teamcenter and Opcenter Quality reduce the complexity of inspection planning
In order to optimize the inspection planning for Siemens Mobility GmbH, a linking of the inspection data with the design data was made possible
Challenges
Many different software solutions and programs complicate the inspection process for Siemens Mobility GmbH.
-
High manual effort for a detailed inspection on the part of the inspector and worker
-
Entering the characteristics in Siemens Opcenter Quality (formerly QMS Professional) takes additional time and is prone to errors
-
Linking the design data with the inspection data
-
Reduce complexity in inspection planning
The key to success
-
Inspection planning with Siemens Opcenter Quality management software requires characteristic data from 3D model
-
BCT Inspector transfers this data directly to Siemens Opcenter Quality for effective quality management
-
BCT Inspector enables characteristic identification and ballooning of geometry and part
-
Over the entire life cycle of the part, its inspection characteristics are kept
-
Critical characteristics can be taken over into the inspection planning process and are sent to Siemens Opcenter Quality
-
During a revision of the geometry data, the BCT Inspector automatically recognizes the changes of the ballooned characteristics
